Mercury Cougar Owners banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2,991 Posts
Jimk127, there is a nut on each side that holds the molding. Just reach inside the wheel wells where the front of the rocker moldings are and feel around. John
 

·
Registered
Joined
·
524 Posts
I'm not sure, I'll check the repair manual for a dooron ;P hehe
 

·
Registered
Joined
·
175 Posts
After you remove the nuts from inside the fender wells, just push down on the rocker molding with the palm of your hand and it should release at the bottom. It should just about fall off. Make sure you save your clips, they are better than the repops.
 
1 - 4 of 4 Posts
Top