Mercury Cougar Owners banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,159 Posts
Discussion Starter #1
I replaced my quarters and the pieces that weld to the front of the quarters, the rocker panels, and the inside rear panels. I couldn't remove the original door striker screws, and the replacement panels didn't have the strikers/back plates. I bought new strikers but still need those plates. I figure they're just like the plates used to anchor the door hinges in place. I do have parts to trade. Lemme know. Thanks, Eric in WI.
 

·
Registered
Joined
·
1,159 Posts
Discussion Starter #2
Don, I left a message on your WCCC site. Do you have any bars that I can use with my door strikers? Eric
 

·
Registered
Joined
·
1,159 Posts
Discussion Starter #3
Picked up the right thickness metal at a local shop dumpster, bought a tapper and fabricated what I needed. Still fun to know I have work to do. Just about ready to start painting everything. All my bolt-on parts and body were treated to brown heavy metal primer from Rustoleum, and haven't seen any signs of rust-through - that's maybe four or five years back.
 
1 - 3 of 3 Posts
Top