[calcat]

When I use my turn signals, it takes about 6 seconds before they actually start sequencing. It would be nice if they started working before I actually made the turn Any suggestions on how to remedy this?

 

[fordsnharleys]

check ground

sounds like you have a bad or weak ground wire, check for that.
one more possibility could be excessive resistance (weak wire) in the power wire.

 

[bruter]

Just thinking...is the sequencer running during those 6 seconds??

 

[calcat]

No, the sequencer starts after that, I can hear it when it kicks in.

 

[bruter]

Ok, so much for the easy solution...from this point I'm pretty much guessing but it may also be a bad relay...but which one, there are so many in the system??? I guess I'll increase my bid on that sequential manual on eBay!!!!!!!!!!:

 

[rbaney]

slow or sticky

Definetly sound like a slow or sticky relay to me. Well looks like it might be time to break out the wiring diagrams. Check all the connections I realise this maybe a few but check all if them for corrosion and loose pins thats my best guess.