Mercury Cougar Owners banner

1 - 4 of 4 Posts

·
Registered
Joined
·
889 Posts
Discussion Starter #1 (Edited)
Por 15 is great stuff,the corrall stuff comes in a spray,The Question is,CanI buy Por 15 and dump it in a hand pressure tank? I did it with UPS 30 It will dilute but what should I use? I would like to do the inside of the frame rails and doors ect. Will it dry hard and leave the drain holes open.I was thinking lacquer thinner?
 

·
Registered
Joined
·
3,201 Posts
Does'nt it tell you on the can, "clean up with......' or 'if you accidently spill any, wipe off with......'. Whatever the cleaning stuff is will also be what you can mix it with
 

·
Registered
Joined
·
889 Posts
Discussion Starter #3
yeh

but Im looking for a solvent that will leave a good coat.Laquor thinner will cut about anything im looking for a ratio of sort that I can do it with.If not,I"ll waste a spayer and write a review.Some of the rust proofing here they spray the s*&%t out of them and it all goes down to the drain holes and clogs them up.Then you end up with door and 1/4 panel rot.If no one has done this I will do a review. hey,sixt9cougar where are you man? you got alot of catchin up to do.
 

·
Registered
Joined
·
794 Posts
I've got Eastwoods rust encapsulator and instructions say :

"may be thinned up to 20% with laquer thinner for spraying"
 
1 - 4 of 4 Posts
Top