I was going thru my old picture collection and found a few pix of the connectors I made. These were rough fittings of them, and transferred the floor pan cut out onto my new floorpan. When I find the rest, I'll scan them too and post them. The drivers side is done, and the passenger side just needs to have the floor pan finished welded up, and the seat riser tached on again. I used 3x2" metal and made a 3 piece connector going from the front frame channel and another from the rear torque box, and fit the center piece to but against the other 2. Cost me about 25. Canadian in the metal, and time.
http://www.mercurycougar.net/gallery/showphoto.php?photo=1120
there's 2 pictures.
Rick
http://www.mercurycougar.net/gallery/showphoto.php?photo=1120
there's 2 pictures.
Rick