Mercury Cougar Owners banner

1 - 2 of 2 Posts

·
Registered
Joined
·
56 Posts
Discussion Starter #1
Anyone have a problem with their seat tracks bowing in the center over time? It serves to cause the seats to settle lower than original height. Makes me feel like I'm sitting in a hole.

Has anyone fixed them on their own by bending them back and reinforcing or is it better to just replace them altogether? And if replacing them, how do you keep it from happening again over time?

Thanks.
 

·
Registered
Joined
·
56 Posts
Discussion Starter #2
I set my seats up side by side on my work bench to look at them. You can tell the drivers side is lower by about an inch. In browsing around this site, I saw a link to a parts provider that shows spacers between the sliders and the seat frames. I figure I can probably just get a longer bolt and use a series of washers to raise the seat.

Anyone do this on your own seats?
 
1 - 2 of 2 Posts
Top