Mercury Cougar Owners banner

1 - 4 of 4 Posts

·
Registered
Joined
·
32 Posts
Discussion Starter #1
I just replaced my old power steeing control valve with a new one, only one problem, one of the lines is too lage to conect to the new unit. The large line fits and two lines that are 5/16 in diameter fit but the fourth line doesn't. The fourth line is also 5/16 in diameter which was fine with the old unit, but the new unit has one opening that is 3/16 in diameter. Any suggestions would be greatly appreciated. Thanks
 
1 - 4 of 4 Posts
Top