Mercury Cougar Owners banner

1 - 3 of 3 Posts

·
Registered
Joined
·
437 Posts
Discussion Starter #1
I was tinkering with the cat today to try to free up the passenger side seat to slide more easily than it does. It doesn't slide at all. I got the seat out very easily and noticed that the rear inside nut was not there. I was very easily able to slide the rails of the seat while it was out, just not in the car. After re-installing the seat and tightening the nuts, the seat did not slide again. HMM. I am hoping that if I get a 4th nut that perhaps this is all that will be needed. I am sure this is wishfull thinking, but I want to get a 4th nut anyways, so I'll use this as a starting point.
This might be one of those phone call vs. internet order from WCCC if I can't find someone here with one just laying around. Please post up if you have one laying around. The nut is 1/2 inch and it has a flattened "washer" as a part of the nut.
Thank you.
 

·
Registered
Joined
·
390 Posts
Yea I know exactly the nuts you need, they are unique but a typical 5/16x18 nut with a fender washer will do just fine, put the plug back over the hole and nobody will know the difference, at least for now till you get the right one.
 
1 - 3 of 3 Posts
Top