Mercury Cougar Owners banner

1 - 4 of 4 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter #1
Hey there everyone, I looked about around here on the forums and through google but didn't really find anything that answered my question. My question is, what motor mounts do I need for a 351w going into a '69 XR7? I pulled the engine out of an '87 bronco, will these work? If not where can I get the correct ones?
 

·
Moderator
Joined
·
11,000 Posts
You need the stock motor mounts for a '69 Cougar. The 351W was the base engine, and the most common in 1969. Any auto part store should be able to supply them to you.
 

·
Registered
Joined
·
11,950 Posts
Your also gonna need some other stuff - I think the oil pan and pickup tube will need to be swapped out (unless that one is a rear sump?) also note the loaction of the water pump outlet - you may need a diffrent rad if it's on the wrog side. Whatch going to do for ignition then? Are you pulling in all the electronics or converting that? Your timing cover wil need to be swapped for one with a fuel pump boss on it - unless you go electric...
 
1 - 4 of 4 Posts
Top