Mercury Cougar Owners banner

1 - 4 of 4 Posts

·
Registered
Joined
·
726 Posts
Discussion Starter #1
I'm planning on installing the ELFI that 1969XR7Vert (Bob) builds because my original low fuel light didn't work. I'm also installing a new single prong fuel sending unit (gas readings were very erratic). Can someone please help with which wire (of the 2 in the cable) to use to connect to the single post on the new sender?:confused:
Thanks.
 

·
Premium Member
Joined
·
13,577 Posts
(Raises hand) Oooh, Oooh!!! Oooh, Oooh!!!

Harry,

Plug the connector socket hole on the yellow with white tracer wire side onto the sender single post. The other with the green with white tracer is/was for the thermistor and the third is just a hole where the original LF sender had a plastic locating prong.

I will make a point to add this to the ELFI kit instructions.

Let me know if you have any questions.

Regards,

Bob
 
1 - 4 of 4 Posts
Top