[Hugh Lawson]

I have a 69 Cougar that had it's wiring harness ripped apart, not by me, and I had to replace it with a painless wiring kit. However I can't figure out how to connect the blower motor to the resistor and power. I have the shop manuals and it's not shown there either!

Any advice or diagrams would be a great help.

Hugh

 

['69cugr]

Orange wire comes from the motor thru the firewall just above the heater box and plugs into the single spade on the heater box. the black wire on the motor grounds to the rear inner fender just below the hinge. There should be another couple of orange wires from your harness that then plug into the double spade on the the heater box.

 

[xr7g428]

He is using a painless kit, so factory codes don't mean much.

 

['69cugr]

True, but even the aftermarket replacement motors use the balck and orange wires