[FastbackAndy]

Merry Christmas!

Anyone tackled the floor pans under the rear seat? After replacing the front floorboards I started to cleanup the rears and found some smaller holes both on the panel under the rear seat, as well as in the molded areas directly behind. The Mustang sheet metal looks similar, but any piece that I could buy would definately be much larger than the pieces that I actually need. Any ideas?

 

[Smith Brother]

Well, you can take pieces that are to LARGE, and cut and use ONLY the portion you need. You can also make your own, unless there is a lot of contours you can't duplicate.

Pictures would help, HINT..............

Dale in Indy

 

[FastbackAndy]

The problem is that shipping to me would be outragous cousindering the pieces that I need from this one:

The pans themself would be an option, but only if they are VERY similar to the Cougar parts:

I have marked the parts in red that are a bit rotted in places.

 

[Smith Brother]

If you have any sheet metal skills, you should be able to fab those.

Give it a try.

Dale in Indy