Mercury Cougar Owners banner

1 - 12 of 12 Posts

·
Registered
Joined
·
1,853 Posts
Discussion Starter #1
On the front rotors between the splash shield and I think the spindle there were cork gaskets. I have been un-able to find these. WCCC and Johns Classic Cougars does not have them. Some one told me AutoKraft but looking through their catalog I did not see them. Anyone know where I might find them? Thanks Harv
 

·
Registered
Joined
·
913 Posts
NPD Part#2B1660-2A 3.60 each, page 68 bottom left
 

·
Registered
Joined
·
1,853 Posts
Discussion Starter #3
K, sorry for doubting looked but didn't find it. Thanks again.
 

·
Registered
Joined
·
2,991 Posts
NPD Part#2B1660-2A 3.60 each, page 68 bottom left
K, sorry for doubting looked but didn't find it. Thanks again.
Harvey, the part is listed on there. Towcat, just had an extra 6 listed in the part #. It's actually part #2B160-2A. John :)
 

·
Registered
Joined
·
1,853 Posts
Discussion Starter #5
I down loaded both pdf catalogs and didn't find it? NpD? Is this autocrafters? Not sure I am even looking in the right web sight. Not all that computer savey.
 

·
Registered
Joined
·
2,991 Posts
I down loaded both pdf catalogs and didn't find it? NpD? Is this autocrafters? Not sure I am even looking in the right web sight. Not all that computer savey.
Harvey, NPD (National Parts Depot) & Autokrafters are different websites. The NPD catalog that towcat's referring to is the 1965-1973 Mustang catalog. Edit: Hopefully this link will work. http://npd.dirxion.com/skin/entrymap/entrymap_thumbnail.asp . Just click on the 1965-1973 Mustang catalog. John
 

·
Registered
Joined
·
384 Posts
I just cut it out of cork sheets
I used the plate as a guide
 

·
Registered
Joined
·
1,853 Posts
Discussion Starter #9
Well that would explain why I didn't find it! I had never looked at a mustang catalog. Thanks again for all the help.
 

·
Registered
Joined
·
1,853 Posts
Discussion Starter #10
Found it! Help when looking in the right catalog.
 

·
Registered
Joined
·
8,194 Posts
I made replacement gaskets from toolbox drawer lining material.
 

·
Registered
Joined
·
1,853 Posts
Discussion Starter #12
I have an old roll of cork out in the garage but my cutting skills aren't that great, Not that anyone will ever see them but If I can get the right I would rather buy them.
 
1 - 12 of 12 Posts
Top