Mercury Cougar Owners banner

1 - 2 of 2 Posts

·
Registered
Joined
·
120 Posts
Discussion Starter #1
I was looking at putting on my repo front spoiler but there doesn't look like theres enough fiberglass to match up to the holes on the panel it should bolt to?
 

·
Registered
Joined
·
1,884 Posts
So this car has had a previously installed front spoiler? In my experience changing these out, its almost impossible to re-drill the replacement spoiler to match the holes in the old one. You might get lucky and hit a few close enough to work, but generally you're better off drilling new holes through the spoiler into the valance. Hard to do, unless you have a friend to hold the spoiler in position while you drill the first few holes and get enough screws in place that it'll support itself.
 
1 - 2 of 2 Posts
Top