Mercury Cougar Owners banner

1 - 12 of 12 Posts

·
Supporting Vendor
Joined
·
1,014 Posts
Discussion Starter #1
Just picked up a GT 390-4 speed car with decent black bucket seat interior. The 4 speed is spoken for but have many other good parts.
 

·
Registered
Joined
·
1,237 Posts
Does this car have a center console?
 

·
Registered
Joined
·
2,055 Posts
The car can't be saved? Always one of my favorites.
 

·
Registered
Joined
·
8,194 Posts
I need the plastic clips for the trunk molding. If the clips on this car are no good, any idea if the clips are available from a Torino parts vendor?
 

·
Registered
Joined
·
2,660 Posts

·
Registered
Joined
·
8,194 Posts

·
Registered
Joined
·
2,660 Posts

·
Registered
Joined
·
8,194 Posts
Nothing there either. I did Google searches for these parts earlier and found nothing. There are two clips that go into the molding and then go through holes in the edge of the trunk lid, held by nuts on the backside. The rest are nylon pieces that slip over "nail heads" in the trunk lid edge, then the molding snaps onto the nlon pieces. Unfortunately this molding is not the same size as the similar one on a Mustang, and none of the Dorman-style packs has anything close in size.
 

·
Registered
Joined
·
2,660 Posts
Try this used Torino Cyclone parts place : [email protected]
or call at 503-289-3084
 

·
Registered
Joined
·
8,194 Posts
OK. Thanks, Don.
 

·
Supporting Vendor
Joined
·
1,014 Posts
Discussion Starter #11
No it does not.
 

·
Supporting Vendor
Joined
·
1,014 Posts
Discussion Starter #12
I suppose anything could be saved but this one has sat outside since 1977. Engine is froze up, rust on top of quarter panel. I bought it for the drive train.
 
1 - 12 of 12 Posts
Top