Mercury Cougar Owners banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1,159 Posts
Discussion Starter #1
Been so long since I picked up those replacement full quarters last August, but think I'm finally ready to fit it in place tomorrow. I just have one piece that needs to come off - the bottom front wheel well piece that fits over the end of the rocker. I have the door jamb, wheel well, and rear piece (welds to the taillight piece) all ready.

Question is around the seam material I should use between the quarter panel front bottom that welds to the rocker panel. Do I just need to pick up some welder's caulk, which is the same stuff I used between the two cowling pieces, and then as well the cowling to the instrument frame area? Will try to post some pics first thing tomorrow. Eric.
 
1 - 1 of 1 Posts
Top