Mercury Cougar Owners banner

1 - 2 of 2 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
I am in need of some more information. I have the 351C V2 in my 74 Cougar. The car was just given to me and has been sitiing for about 12 years. I was pulling off the heater hoses when I ATTEMPTED to remove the hose that feed into the block behind the waterpump, the hose came off along with the the "spout?" that the hose fits around. I am still new at this and i was under the impression the heater hoses fit into the water pump not the block. My problems is now that I broke the "spout' that is in the block "how" i can get this repaired. Does anyone know if this "spout" is a part of the block or if the "spout" screws into the block somehow.

PS: how close is the 1974 Cougar XR-7 to the 1974 Torino?

74Cougar:1zhelp:
 

·
Registered
Joined
·
168 Posts
bad memory

If memory serves we had the same problem that spout is pressed into the block. If you dont care about being sock we drilled and tapped the hole and screwed in our own. Sorry memory is fuzzy on the size of tap and spout. Also they do not reproduce the spout. Good luck
 
1 - 2 of 2 Posts
Top