Mercury Cougar Owners banner

1967 cougar project in San Pedro California

2K views 0 replies 1 participant last post by  Tkosinski2 
#1 ·
Unfortunately it’s time to sell my cougar. I’m moving out of state and won’t be able to take it with me. I have a ton of parts for the car. I don’t really want to get rid of the car but the move is forcing me to sell quick. If any interest please make an offer.
1967 cougar hardtop 289 automatic

The good:
TCP Monte Carlo bar
TCP subframe connectors
TCP X-brace
TCP drive shafts safety loop
Fresh rebuilt c4 transmission
Brand new AR Torq thrust II 17” wheels
1968 single piston front discs
Engine gaskets all replaced including rear main
Fresh rebuilt Holley 4150 vacuum secondary electric choke carb
New upper a arms, 68 lower arms, 68 caster rods, inner and outer tie rods
Stainless steel hard brake lines
New flex lines for brakes
New rear wheel cylinders
Stainless steel 3/8” fuel lines
New brass heater core and rebuilt box with new seals
New mass backed floor carpet
90% interior
Electric headlight conversion with wiring for plug and play directly to battery

The bad:
Typical light rust in doors and rear fenders
Needs patching in right rear windshield area
Vehicle is in tear down
Suspension is not installed
In process of replacing drivers floor pan (currently cut out)
Vehicles needs to be assembled.
No battery

Asking 3500 or best offer as is with all extras

I will be working on it to get it back on the ground and moveable but if I get the floor pan in and car put back together I will be raising the price to 5000 or best offer

Email tkosinski2@gmail.com
 
See less See more
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top